1/29/2024 0 Comments 12 volt battery monitor![]() A full instruction manual is included and all of our products come with a 12 month warranty. If more current is required a relay unit can be fitted to allow more switching capacity. This switch can be used to control any load up to 30 Amp, this would be more than enough to run an entire campsite worth of LED lights. The internal circuit wiring is big enough to supply standard portable fridge / freezers. All of our products are manufactured from automotive rated components for maximum power delivery and reduced voltage drop. A LED indicator mounted between the two connectors allows you to see when the switch is activated and power is available. The fitted plugs are compatible with all Anderson 50A connectors. Extra remotes are available if required, and all units are individually coded to avoid interference. Ideally suited for off road 4X4, and caravans, or anywhere else you want to remotely control 12 volt equipment. The unit is comprised of a DC 12V Remote control receiver fitted with 2 quality Anderson style plugs and a matching remote transmitter. With the capability of 30A, this switch can control the whole average camp. The BM12V can be used to monitor conventional 12 Voltlead-acid batteries and has been designed to withstand themost demanding environments. A full instruction manual plus a Voltage vs charge table is included.Īll of our products come with a 12 month warranty. By using two of these meters you can tell if your battery system is charging or discharging at any given moment. This meter can measure current out of the battery to a load, or charge from a solar panel or battery charger into the battery, depending on where it is connected. When used correctly, this meter can give an indication of remaining charge left in your battery. ![]() It is ideally suited for solar panels, camping trips, and inverter systems. The Volt Amp meter, is a DC 12V/24V Voltage and current monitor fitted with 2 quality Anderson style plugs and a permanently connected Volt/Amp meter. Replacing R3 with a variable resistor in series with a 1K resistor enables the brightness of the LEDs to be easily changed for example for indoor or outdoor use.Volt Amp meter with Anderson style connections Increasing the value reduces the brightness (and also reduces current consumption), decreasing the value increases the brightness (and also increases the current consumption). To change the brightness of the LEDs, R3 can be changed. In BAR mode the current consumption would be increased by an amount depending on the number of LEDs turned on up to around 100mA when the battery is full. In DOT mode the circuit shown above would draw under 10mA. With BAR mode – achieved by connecting pin 9 to the incoming positive voltage – all LEDs up to the measured voltage are on at the same time like a bar graph. With DOT mode (as used in our example above) only one LED is on at a time. With the resistor values used, you will just need to check that the first red LED turns off as it should at 11.89V. ![]() To calibrate the monitor, connect it to 12.65V and adjust the 10K potentiometer (VR1) until the last green LED turns on. The other LEDs will turn on one by one as the measured voltage increases through the range. the first red LED (D1) will light up at a voltage of 11.89V which is a virtually empty 12V lead acid battery, and the last green LED (D10) will light up at a voltage of 12.65V corresponding to a full 12V lead acid battery. The values of the resistors are R1 = 56K, R2 = 120K + 47K, R3 = 3K9 to give us an 11.89V to 12.65V voltage range – i.e. Above is shown the schematic for our 12 Volt battery monitor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |